• February 23, 2020, 08:18:04 PM
Welcome, Guest. Please login or register. Registration is free.
Did you miss your activation email?

Author Topic: To SLPP or to not SLPP  (Read 2575 times)

0 Members and 1 Guest are viewing this topic.

Offline emerenziano

  • Rookie
  • **
  • Posts: 2
To SLPP or to not SLPP
« on: May 01, 2010, 03:14:05 PM »
Dear all,

I just need advise on this topic.

I have four ERS8600 in a square arrangement with SLPP enabled as suggested in the recommendations for a routed core ( Rx = 5 on the primary switch cluster member and 50 on the secondary member on both clusters). Now I have to transport ELAN and TLAN across my network without routing them. I will, thus, end up with a mixed core. Should I enable SLPP also on ELAN and TLAN? Should I modify the Rx parameters on the core ports? Or other suggestions?

Ciao

Alberto


Offline Michael McNamara

  • Administrator
  • Hero Member
  • *****
  • Posts: 3841
    • michaelfmcnamara
    • Michael McNamara
Re: To SLPP or to not SLPP
« Reply #1 on: March 11, 2012, 11:51:27 AM »
Hi emerenziano and welcome!

I was just looking over some forum threads and I see that I missed your post, I'm sorry about that.

You can route and bridge between you core without any issue. I personally don't run SLPP in every VLAN I only run it in my edge/closet VLANs and in my management VLAN. I would probably advise against running it in the ELAN VLAN since the CS1000 doesn't like broadcast traffic (it's been known to INI if it gets hit with too many broadcast packets).

Sorry again!
We've been helping network engineers, system administrators and technology professionals since June 2009.
If you've found this site useful or helpful, please help me spread the word. Link to us in your blog or homepage - Thanks!