• December 12, 2018, 10:26:52 AM
Welcome, Guest. Please login or register. Registration is free.
Did you miss your activation email?

Author Topic: Avaya 5520 VLACP  (Read 86 times)

0 Members and 1 Guest are viewing this topic.

Offline AVAGO

  • Jr. Member
  • **
  • Posts: 44
Avaya 5520 VLACP
« on: November 12, 2018, 12:37:23 PM »
Hi
  I have been looing at the guide done by Michael ( https://blog.michaelfmcnamara.com/2012/03/is-vlacp-right-for-me/)

I have two switch's in a stack ( SVR_Stack )  from stack SVR_Stack I have setup a MLT from ports 1/47,2/47 and these will connect to a 3 switch ( Stack_A) on ports 1/47,3/37
On the SVR_Stack I have run the following
IND_SRVR_ST_SW(config)#interface fastEthernet 1/47,2/47
IND_SRVR_ST_SW(config-if)#vlacp port 1/47,2/47 timeout short
IND_SRVR_ST_SW(config-if)#vlacp port 1/47,2/47 timeout-scale 5
IND_SRVR_ST_SW(config-if)#vlacp port 1/47,2/47 fast-periodic-time 500
IND_SRVR_ST_SW(config-if)#vlacp port 1/47,2/47 enable
IND_SRVR_ST_SW(config)#vlacp macaddress 01:80:c2:00:00:0f
IND_SRVR_ST_SW(config)#vlacp hold_time 20
IND_SRVR_ST_SW(config)#vlacp enable

I have 4  questions

1) Where I have set the VLACP MACADDRESS - where is this obtained from ? I used the one in the guide

2) If I have another MLT using ports 1/48,2/48 going to another 3 switch stack ( Stack_B ) do I repeat the commands above but for 1/48,2/48 ?
3) do I have to use a different MACADDRESS for each MLT ?

the setup would be  Server_Stack with 2 MLT - one to Stack_A and the other from Server_Stack to Stack_B

Svr_Stack ports 1/47,2/47 --> Stk_A  1/47,3/47

Svr_Stack ports 1/48,2/48 --> StK_B 1/48,3/48

4) You don't run spanning tree on trunk ports ? but you do on all other port ?

thanks in advance