• October 16, 2018, 03:42:14 PM
Welcome, Guest. Please login or register. Registration is free.
Did you miss your activation email?

Author Topic: Add VSP to existing stack question  (Read 907 times)

0 Members and 1 Guest are viewing this topic.

Offline CptnBlues63

  • Sr. Member
  • ****
  • Posts: 100
Add VSP to existing stack question
« on: February 27, 2017, 03:40:44 PM »
I have a redundant cluster of VSP7000's (sides A and B).  Both sides of my cluster are presently two switch stacks. 

I'm in need of more 10 GB connections so will be adding a 3'd switch to the two stacks in the near future but before I do so, I thought it would be a good idea to check in here first to see if there are any issues or "gotchya's" I should know about.

I've done it on 5500's and 5600's but never on the VSP7000's so I'm hoping someone here has and can let me know if there are any issues I should know about.

Thanks in advance!


Offline MatzeKS

  • Sr. Member
  • ****
  • Posts: 300
    • matzeks
    • Controlware GmbH - Germany
Re: Add VSP to existing stack question
« Reply #1 on: March 03, 2017, 02:44:55 AM »
Its completely the same procedure, but the same (BOSS) code stream runs inside.
Make sure your new box has the same Firmware and Software loaded and the Base-Selector Switch on the Front-Panel is set NOT to Base.

Good luck
------------------------------------------------------
ACE-Fx #00050

Offline CptnBlues63

  • Sr. Member
  • ****
  • Posts: 100
Re: Add VSP to existing stack question
« Reply #2 on: March 07, 2017, 11:54:32 AM »
Its completely the same procedure, but the same (BOSS) code stream runs inside.
Make sure your new box has the same Firmware and Software loaded and the Base-Selector Switch on the Front-Panel is set NOT to Base.

Good luck

That's what I figured, and expected, but thought it would be smart to ask here first and get confirmation. 

Thanks a lot for the info!