• November 16, 2018, 08:14:49 PM
Welcome, Guest. Please login or register. Registration is free.
Did you miss your activation email?

Author Topic: RFS7000 with AP300  (Read 8926 times)

0 Members and 4 Guests are viewing this topic.

Offline IGER

  • Rookie
  • **
  • Posts: 9
Re: RFS7000 with AP300
« Reply #15 on: June 05, 2013, 03:49:12 AM »
Hi,
Ntp is Ok.
For speed/duplex I need replace hub equipment with switch into 8 stores.
Thanks
Regards


Offline hchen01

  • Full Member
  • ***
  • Posts: 73
Re: RFS7000 with AP300
« Reply #16 on: June 11, 2013, 09:33:23 PM »
I use RFS7000 with firmware 5.2.0.0-069R and 60 AP300.
Between RFS7000 and AP300 there is a wan with ADSL lines 512 KB.

From personal perspective:
 AP300 is dependent access point, and it will send all the data back to the RFS7000(including the management traffic and data traffic), so the 512KB ADSL should be the bottleneck(60 APs).
you can check the static information on the RFS7000.

I suggest replacing AP300 with AP6521/AP6522, and using local switching.


Offline IGER

  • Rookie
  • **
  • Posts: 9
Re: RFS7000 with AP300
« Reply #17 on: September 23, 2017, 02:44:23 AM »
Hi,
I need to install a new RFS7000.
I want modify ip address of ge1. I log on RFS7000, I choose enable, config.
At prompt, rfs7000-182DDF(config)*# interface ge1. I have this error 
% Invalid input detected at '^' marker.

What can I do?
Regards