Hi,
I configured a new WSS 2361 and finally decided to upgrade the firmware at the end (WITHOUT MAKING A BACKUP - Smack me). Now when the switch boots, it looks like it cannot load the boot image.
How do I factory default the WSS or is there a way I can restore it to the previous boot image (hopefully save the work I do if possible)?
Wireless Switch Bootstrap 6.0 Release
OK
unzip file len 1281760 OK
OK
unzip file len 158229 OK
Reset cause is FUGU_RESET_CAUSE_COLD.
Wireless Switch Bootstrap/Bootloader
Version 6.0.9 Release
Compiled on Wed Oct 31 19:20:18 PDT 2007 by $LOGNAME
Bootstrap version: 6.0 Active
Bootloader 0 version: 6.0.9 Active
Bootloader 1 version: 6.0.9
Mainboard Revision: 15.
FPGA Controller Revision: 32.
/
BOOT Index: 0
BOOT TYPE: c
DEVICE: boot1:
FILENAME: default
FLAGS: 00000000
OPTIONS: run=nos;root=md0a
boot>The ? command gives me these options:
boot> ?
ls Display a list of all commands and descriptions.
help Display help information for each command.
autoboot Display the state of, enable, or disable the autoboot option.
dhcp Display the state of, enable, or disable the DHCP option.
boot Load and execute an image using the current boot configuration profile.
change Change the current boot configuration profile.
create Create a new boot configuration profile.
delete Delete the current boot configuration profile.
next Select the next boot configuration profile.
show Display the current boot configuration profile.
dir Display the contents of the specified boot partition.
fver Display the version of the loadable image specified by device:filename.
version Display HW and Bootstrap/Bootloader version information.
reset Reset the system.
test Display the state of, enable, or disable the tests option.
Any help would be appreciated.
Thanks
